Set Up UCR 2008 in Phone Configuration Window

Set Up UCR 2008 in Phone Configuration Window

Set Up UCR 2008 in Phone Configuration Window


Use this procedure to set the following parameters:

  • SSH Access
  • Web Access
  • HTTPS Server

 

Procedure

Step 1

Choose Device > Phone.

 

Step 2

Set the SSH Access parameter to Disabled.

 

Step 3

Set the Web Access parameter to Disabled.

 

Step 4

Set the HTTPS Service parameter to HTTPS only.

 

Step 5 

Click Save. 

    • Related Articles

    • Set Up UCR 2008 in Enterprise Phone Configuration Window

      Set Up UCR 2008 in Enterprise Phone Configuration Window   Use this procedure to set the following parameters: FIPS Mode HTTPS Server 80-bit SRTCP   Procedure   Step 1 Choose System > Enterprise Phone Configuration.   Step 2 Set the FIPS Mode ...

    • Set Up UCR 2008 in Common Phone Profile Configuration Window

      Set Up UCR 2008 in Common Phone Profile Configuration Window Use this procedure to set the following parameters: FIPS Mode SSH Access 80-bit SRTCP   Procedure   Step 1 Choose Device > Device Settings > Common Phone Profile.   Step 2 Set the FIPS Mode ...

    • UCR 2008 Setup

      UCR 2008 Setup The parameters that support UCR 2008 reside in Cisco Unified Communications Manager Administration.   The following table describes the parameters and indicates the procedure to change the setting. Parameter Administration Path ...

    • Set Up Remote Phone

      Set Up Remote Phone Cisco IP Phones that are configured for SSL VPN to ASA using the built-in client in a remote locaiont (for example, a home office) have a special configuration requirement.   We recommend that you provide the phone with an ...

    • Set PC Port Configuration Field

      Set PC Port Configuration Field To configure the setting on multiple phones simultaneously, enable Remote Port Configuration in Enterprise Phone Configuration (System > Enterprise Phone Configuration).   Note If the ports are configured for Remote ...