Set Up UCR 2008 in Common Phone Profile Configuration Window
Set Up UCR 2008 in Common Phone Profile
Configuration Window
Use this procedure to set the following
parameters:
-
FIPS Mode
-
SSH Access
-
80-bit SRTCP
Procedure
Step 1
Choose Device > Device Settings > Common Phone Profile.
Step 2
Set the FIPS Mode parameter to Enabled.
Step 3
Set the SSH Access parameter to Disabled.
Step 4
Set the 80-bit SRTCP parameter to Enabled.
Step 5
Click Save.
Related Articles
Set Up UCR 2008 in Enterprise Phone Configuration Window
Set Up UCR 2008 in Enterprise Phone Configuration Window Use this procedure to set the following parameters: FIPS Mode HTTPS Server 80-bit SRTCP Procedure Step 1 Choose System > Enterprise Phone Configuration. Step 2 Set the FIPS Mode ...
Set Up UCR 2008 in Phone Configuration Window
Set Up UCR 2008 in Phone Configuration Window Use this procedure to set the following parameters: SSH Access Web Access HTTPS Server Procedure Step 1 Choose Device > Phone. Step 2 Set the SSH Access parameter to Disabled. Step 3 Set the Web ...
UCR 2008 Setup
UCR 2008 Setup The parameters that support UCR 2008 reside in Cisco Unified Communications Manager Administration. The following table describes the parameters and indicates the procedure to change the setting. Parameter Administration Path ...
Set Up Remote Phone
Set Up Remote Phone Cisco IP Phones that are configured for SSL VPN to ASA using the built-in client in a remote locaiont (for example, a home office) have a special configuration requirement. We recommend that you provide the phone with an ...
Set PC Port Configuration Field
Set PC Port Configuration Field To configure the setting on multiple phones simultaneously, enable Remote Port Configuration in Enterprise Phone Configuration (System > Enterprise Phone Configuration). Note If the ports are configured for Remote ...